- 您現在的位置：買賣IC網 > PDF目錄382302 > MC33260PG (ON SEMICONDUCTOR) GreenLine TM Compact Power Factor Controller: Innovative Circuit for Cost Effective Solutions PDF資料下載
參數資料
| 型號： | MC33260PG |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 穩壓器 |
| 英文描述： | GreenLine TM Compact Power Factor Controller: Innovative Circuit for Cost Effective Solutions |
| 中文描述： | 0.5 A POWER FACTOR CONTROLLER, PDIP8 |
| 封裝： | LEAD FREE, PLASTIC, DIP-8 |
| 文件頁數： | 9/22頁 |
| 文件大小： | 232K |
| 代理商： | MC33260PG |
MC33260
http://onsemi.com
9
FUNCTIONAL DESCRIPTION
Pin Numbers are Relevant to the PDIP8 Version
INTRODUCTION
The need of meeting the requirements of legislation on
line current harmonic content, results in an increasing
demand for cost effective solutions to comply with the
Power Factor regulations. This data sheet describes a
monolithic controller specially designed for this purpose.
Most offline appliances use a bridge rectifier associated
to a huge bulk capacitor to derive raw dc voltage from the
utility ac line.
Figure 22. Typical Circuit Without PFC
Load
Converter
Rectifiers
Bulk
Storage
Capacitor
+
AC
Line
This technique results in a high harmonic content and in
poor power factor ratios. In effect, the simple rectification
technique draws power from the mains when the
instantaneous ac voltage exceeds the capacitor voltage. This
occurs near the line voltage peak and results in a high charge
current spike. Consequently, a poor power factor (in the
range of 0.5 0.7) is generated, resulting in an apparent input
power that is much higher than the real power.
Figure 23. Line Waveforms Without PFC
Line Sag
Rectified DC
AC Line Voltage
AC Line Current
0
0
V
pk
Active solutions are the most popular way to meet the
legislation requirements. They consist of inserting a PFC
preregulator between the rectifier bridge and the bulk
capacitor. This interface is, in fact, a stepup SMPS that
outputs a constant voltage while drawing a sinusoidal
current from the line.
Figure 24. PFC Preconverter
Converter
Rectifiers
+
AC
Line
L
B
C
H
B
PFC Preconverter
M
The MC33260 was developed to control an active solution
with the goal of increasing its robustness while lowering its
global cost.
OPERATION DESCRIPTION
The MC33260 is optimized to just as well drive a free
running as a synchronized discontinuous voltage mode.
It also features valuable protections (overvoltage and
undervoltage protection, overcurrent limitation, ...) that
make the PFC preregulator very safe and reliable while
requiring very few external components. In particular, it is
able to safely face any uncontrolled direct charges of the
output capacitor from the mains which occur when the
output voltage is lower than the input voltage (startup,
overload, ...).
In addition to the low count of elements, the circuit can
control an innovative mode named “Follower Boost” that
permits to significantly reduce the size of the preconverter
inductor and power MOSFET. With this technique, the
output regulation level is not forced to a constant value, but
can vary according to the a.c. line amplitude and to the
power. The gap between the output voltage and the ac line
is then lowered, what allows the preconverter inductor and
power MOSFET size reduction. Finally, this method brings
a significant cost reduction.
A description of the functional blocks is given below.
REGULATION SECTION
Connecting a resistor between the output voltage to be
regulated and the Pin 1, a feedback current is obtained.
Typically, this current is built by connecting a resistor
between the output voltage and the Pin 1. Its value is then
given by the following equation:
Vo
Ipin1
Vpin1
Ro
where:
R
o
is the feedback resistor,
V
o
is the output voltage,
V
pin1
is the Pin 1 clamp value.
The feedback current is compared to the reference current
so that the regulation block outputs a signal following the
characteristic depicted in Figure 25. According to the power
and the input voltage, the output voltage regulation level
varies between two values (V
o
)
regL
and (V
o
)
regH
corresponding to the I
regL
and I
regH
levels.
Figure 25. Regulation Characteristic
1.5 V
Regulation Block Output
I
o
I
regL
(97%I
ref
)
I
regH
(I
ref
)
The feedback resistor must be chosen so that the feedback
current should equal the internal current source I
regH
when
the output voltage exceeds the chosen upper regulation
voltage [(V
o
)
regH
].
相關PDF資料 |
PDF描述 |
|---|---|
| MC33263NW-38R2 | Ultra Low Noise 150 mA Low Dropout Voltage Regulator with ON/OFF Control |
| MC33263NW-28R2 | Ultra Low Noise 150 mA Low Dropout Voltage Regulator with ON/OFF Control |
| MC33263NW-33R2 | Ultra Low Noise 150 mA Low Dropout Voltage Regulator with ON/OFF Control |
| MC33263NW-30R2 | Ultra Low Noise 150 mA Low Dropout Voltage Regulator with ON/OFF Control |
| MC33263NW-32R2 | Ultra Low Noise 150 mA Low Dropout Voltage Regulator with ON/OFF Control |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC33261 | 制造商:SPC Multicomp 功能描述:HEATSINK TO220/218 16.7/W 制造商:SPC Multicomp 功能描述:HEATSINK TO220/218 16.7C/W 制造商:SPC Multicomp 功能描述:HEAT SINK; Packages Cooled:TO-218 / TO-220; Thermal Resistance:16.7C/W; External Height - Imperial:1"; External Height - Metric:25.4mm; External Width - Imperial:0.654"; External Width - Metric:16.6mm; Heat Sink Material:Aluminium ;RoHS Compliant: Yes |
| MC33261P | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MC33262 | 制造商:SPC Multicomp 功能描述:HEATSINK TO220/218 12.9/W 制造商:SPC Multicomp 功能描述:HEATSINK TO220/218 12.9C/W 制造商:SPC Multicomp 功能描述:HEAT SINK; Packages Cooled:TO-218 / TO-220; Thermal Resistance:12.9C/W; External Height - Imperial:1.5"; External Height - Metric:38.1mm; External Width - Imperial:0.654"; External Width - Metric:16.6mm; Heat Sink Material:Aluminium;RoHS Compliant: Yes |
| MC33262CDR2 | 功能描述:功率因數校正 IC ANA PFC W/OVERVOLT COMP RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| MC33262CDR2G | 功能描述:功率因數校正 IC ANA PFC W/OVERVOLT COMP RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。