- 您現在的位置：買賣IC網 > PDF目錄382302 > MC33364D2 (ON SEMICONDUCTOR) 50mA Switched-Cap DC/DC Converter 8-MSOP PDF資料下載
參數資料
| 型號： | MC33364D2 |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 穩壓器 |
| 英文描述： | 50mA Switched-Cap DC/DC Converter 8-MSOP |
| 中文描述： | SWITCHING CONTROLLER, 800 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封裝： | PLASTIC, SOP-8 |
| 文件頁數： | 10/16頁 |
| 文件大小： | 170K |
| 代理商： | MC33364D2 |
MC33364
http://onsemi.com
10
The primary inductance value is given by:
max Vin(min)
Lp
Ippk
fmin
0.5(127 V)
(0.472 A)(70 kHz)
1.92 mH
The manufacturer recommends for that magnetic core a
maximum operating flux density of:
Bmax
0.2 T
The cross-sectional area A
c
of the EF20 core is:
33.5 mm2
The operating flux density is given by:
LpIppk
NpAc
From this equation the number of turns of the primary
winding can be derived:
LpIppk
BmaxAc
The A
L
factor is determined by:
2
Ac
Bmax
np
AL
Lp
n2p
LpBmaxAc
LpIppk
2
0.2 T 33.5 E- 6 m22
.00192 H (0.472 A)2
105 nH
From the manufacturer‘s catalogue recommendation the
core with an A
L
of 100 nH is selected. The desired number
of turns of the primary winding is:
1 2
(0.00192 H)
(100 nH)
np
Lp
AL
1 2
139 turns
The number of turns needed by the 6.0 V secondary is
(assuming a Schottky rectifier is used):
ns
Vs
Vfwd1– max np
max Vin(min)
6.0 V
0.3 V 1
0.5 127 V
0.5 139
7 turns
The auxiliary winding to power the control IC is 16 V and
its number of turns is given by:
(Vaux
Vfwd)(1
naux
max)np
max(Vin(min))
(16 V
0.9 V)(1
[0.5(127 V)]
0.5)139
19 turns
The approximate value of rectifier capacitance needed is:
C1
toff(Iin)
Vripple
(5 m sec)(0.118 A)
50 V
11.8 F
where the minimum ripple frequency is 2 times the 50 Hz
line frequency and t
off
, the discharge time of C1 during the
haversine cycle, is assumed to be half the cycle period.
Because we have a variable frequency system, all the
calculations for the value of the output filter capacitors will
be done at the lowest frequency, since the ripple voltage will
be greatest at this frequency. When selecting the output
capacitor select a capacitor with low ESR to minimize ripple
from the current ripple. The approximate equation for the
output capacitance value is given by:
C5
Iout
(fmin)(Vrip)
Determining the value of the current sense resistor (R7),
one uses the peak current in the predesign consideration.
Since within the IC there is a limitation of the voltage for the
current sensing, which is set to 1.2 V, the design of the
current sense resistor is simply given by:
Vcs
Ippk
The error amplifier function is provided by a TL431 on the
secondary, connected to the primary side via an optoisolator,
the MOC8102.
The voltage of the optoisolator collector node sets the
peak current flowing through the power switch during each
cycle. This pin will be connected to the feedback pin of the
MC33364, which will directly set the peak current.
Starting on the secondary side of the power supply, assign
the sense current through the voltage-sensing resistor
divider to be approximately 0.25 mA. One can immediately
calculate the value of the lower and upper resistor:
Vref(TL431)
Idiv
2 A
(70 kHz)(0.1 V)
286 F
R7
1.2 V
0.472 A
2.54
2.2
Rlower
R11
2.5 V
0.25 mA
10 k
Rupper
R10
Vout
Vref(TL431)
Idiv
6.0 V
0.25 mA
2.5V
14 k
The value of the resistor that would provide the bias
current through the optoisolator and the TL431 is set by the
minimum operating current requirements of the TL431.
This current is minimum 1.0 mA. Assign the maximum
current through the branch to be 5 mA. That makes the bias
resistor value equal to:
Vout
ILED
6.0 V
[2.5V
5.0 mA
Rbias
RS
[Vref(TL431)
VLED]
1.4V]
420
430
相關PDF資料 |
PDF描述 |
|---|---|
| MC33364D | 50mA Switched-Cap DC/DC Converter 8-MSOP |
| MC33364D2R2 | Critical Conduction GreenLine SMPS Controller |
| MC33365 | Isolated Flyback Switching Regulator with 9V Output |
| MC33365P | 50mA Switched-Cap DC/DC Converter 8-MSOP |
| MC33368 | High Voltage GreenLine Power Factor Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC33364D2G | 功能描述:電流型 PWM 控制器 Variable Frequency SMPS RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| MC33364D2R2 | 功能描述:電流型 PWM 控制器 Variable Frequency RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| MC33364D2R2G | 功能描述:電流型 PWM 控制器 Variable Frequency SMPS RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| MC33364DG | 功能描述:電流型 PWM 控制器 Variable Frequency SMPS RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| MC33364DR2 | 功能描述:電流型 PWM 控制器 Variable Frequency RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
發布緊急采購，3分鐘左右您將得到回復。