- 您現在的位置：買賣IC網 > PDF目錄382302 > MC33368P (ON SEMICONDUCTOR) 50mA Switched-Cap DC/DC Converter 8-MSOP PDF資料下載
參數資料
| 型號： | MC33368P |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 穩壓器 |
| 英文描述： | 50mA Switched-Cap DC/DC Converter 8-MSOP |
| 中文描述： | 0.01 A POWER FACTOR CONTROLLER, PDIP16 |
| 封裝： | PLASTIC, DIP-16 |
| 文件頁數： | 9/20頁 |
| 文件大小： | 476K |
| 代理商： | MC33368P |
MC33368
http://onsemi.com
9
at very low duty cycles, preventing their destruction. If the
short circuit fault is removed, the power supply system will
turn on by itself in a normal startup mode after the restart
delay has timed out.
Output Switching Frequency Clamp
In normal operation, the MC33368 operates the boost
inductor in the critical mode. That is, the inductor current
ramps to a peak value, ramps down to zero, then
immediately begins ramping positive again. The peak
current is programmed by the multiplier output within the
IC. As the input voltage haversine declines to near zero, the
output switch on–time becomes constant, rather than going
to zero because of the small integrated dc voltage at Pin 5
caused by C2, R3 and R5. Because of this, the average line
current does not exactly follow the line voltage near the zero
crossings. The Output Switching Frequency Clamp
remedies this situation to improve power factor and
minimize EMI generated in this operating region. The
values of R10 and C7, as shown in Figure 15, program a
minimum off–time in the frequency clamp which overrides
the zero current detect signal, forcing a minimum off–time.
This allows discontinuous conduction operation of the boost
inductor in the zero crossing region, and the average line
current more nearly follows the voltage. The Output
Switching Frequency Clamp function can be disabled by
connecting the FC input, Pin 13, to the VCC supply Pin 12.
For best results, the minimum off–time, determined by the
values of R10 and C7, should be chosen so that ts(min) = t(on)
+ t(off)fc. Output drive is inhibited when the voltage at the
frequency clamp input is less than 2.0 V. When the output
drive is high, C7 is discharged through an internal 100
μ
A
current source. When the output drive switches low, C7 is
charged through R10. The drive output is inhibited until the
voltage across C7 reaches 2.0 V, establishing a minimum
off–time where:
t(off)fc
R10 C7 loge
1
2
VCC
Output
The IC contains a CMOS output driver that was
specifically designed for direct drive of power MOSFETs.
The Gate Output is capable of up to
±
1500 mA peak current
with a typical rise and fall time of 50 ns with a 1.0 nF load.
Additional internal circuitry has been added to keep the Gate
Output in a sinking mode whenever the Undervoltage
Lockout is active. This characteristic eliminates the need for
an external gate pull–down resistor. The totem–pole output
has been optimized to minimize cross–conduction current
during high speed operation.
相關PDF資料 |
PDF描述 |
|---|---|
| MC33368DR2 | High Voltage GreenLine Power Factor Controller |
| MC33375ST-3.0T3 | LOW DROPOUT MICROPOWER VOLTAGE REGULATOR |
| MC33375 | LOW DROPOUT MICROPOWER VOLTAGE REGULATOR |
| MC33375ST-1.8T3 | LOW DROPOUT MICROPOWER VOLTAGE REGULATOR |
| MC33375ST-2.5T3 | LOW DROPOUT MICROPOWER VOLTAGE REGULATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC33368PG | 功能描述:功率因數校正 IC High Voltage PFC w/Critical Mode RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| MC33375D-2.5 | 功能描述:低壓差穩壓器 - LDO 2.5V 300mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| MC33375D-2.5G | 功能描述:低壓差穩壓器 - LDO 2.5V 300mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| MC33375D-2.5R2 | 功能描述:低壓差穩壓器 - LDO 2.5V 300mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| MC33375D-2.5R2G | 功能描述:低壓差穩壓器 - LDO 2.5V 300mA RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。