- 您現在的位置：買賣IC網 > PDF目錄371050 > MC68HC11K0VFN2 (MOTOROLA INC) 8-BIT MICROCONTROLLER PDF資料下載
參數資料
| 型號： | MC68HC11K0VFN2 |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT MICROCONTROLLER |
| 中文描述： | 8-BIT, MROM, 2 MHz, MICROCONTROLLER, PQCC84 |
| 封裝： | PLASTIC, LCC-84 |
| 文件頁數： | 25/80頁 |
| 文件大小： | 420K |
| 代理商： | MC68HC11K0VFN2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁當前第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
M68HC11 K Series
MC6HC11KTS/D
MOTOROLA
25
ROMAD —ROM/EPROM Mapping Control
In single-chip mode ROMAD is forced to one out of reset.
0 = ROM/EPROM located at $2000–$7FFF
1 = ROM/EPROM located at $A000–$FFFF
Bit 6 —Not implemented
Always reads one
CLKX —XOUT Clock Enable
0 = XOUT pin disabled
1 = Buffered XTAL signal (four times E frequency) driven out on the XOUT pin
PAREN —Pull-Up Assignment Register Enable
0 = Pull-ups always disabled regardless of state of bits in PPAR
1 = Pull-ups either enabled or disabled through PPAR
NOSEC —Security Disable
NOSEC is invalid unless the security mask option is specified before the MCU is manufactured. If se-
curity mask option is omitted NOSEC always reads one. Refer to
3.6 Security Feature
.
0 = Security enabled
1 = Security disabled
NOCOP —COP System Disable
Resets to programmed value
0 = COP enabled (forces reset on timeout)
1 = COP disabled (does not force reset on timeout)
ROMON —ROM/EPROM Enable
In single-chip mode, ROMON is forced to one out of reset. In special test mode, ROMON is forced to
zero out of reset.
0 = ROM/EPROM removed from memory map
1 = ROM/EPROM present in memory map
EEON —EEPROM Enable
0 = EEPROM disabled from memory map
1 = EEPROM present in memory map with location depending on value specified in EE[3:0] in INIT2
3.6 Security Feature
The security feature protects memory contents from unauthorized access. Although many devices in
the M68HC11 family support the security feature, an enhancement has been added to the MC68S11K4
that protects the contents of EPROM/OTPROM.
The security feature affects how the MCU behaves in certain modes. When the optional security feature
has been specified prior to manufacture and enabled via the NOSEC bit in CONFIG, the MCU is re-
stricted to operation in single-chip modes only. When the NOSEC bit equals zero, the MCU ignores the
state of the MODA pin during reset. This allows the MCU to be operated in single-chip and bootstrap
modes only. These modes of operation do not allow external visibility of the internal address and data
buses. Although the security feature can easily be disabled when in bootstrap mode, the bootloader
firmware residing in bootstrap ROM checks to see if the NOSEC bit is clear. If NOSEC is clear (security
enabled), the bootloader program performs the following:
CONFIG
—System Configuration Register
$003F
Bit 7
6
5
4
3
2
1
Bit 0
ROMAD
1
CLKX
PAREN
NOSEC
NOCOP
ROMON
EEON
RESET:
—
1
—
—
—
—
—
—
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HC11K0VFN3 | 8-BIT MICROCONTROLLER |
| MC68HC11K0VFN4 | 8-BIT MICROCONTROLLER |
| MC68HC11K0VFU2 | 8-BIT MICROCONTROLLER |
| MC68HC11K0VFU3 | 8-BIT MICROCONTROLLER |
| MC68HC11K0VFU4 | 8-BIT MICROCONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC11K0VFN3 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Technical Summary 8-Bit Microcontroller |
| MC68HC11K0VFN4 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:8-Bit Microcontroller |
| MC68HC11K0VFU2 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:8-Bit Microcontroller |
| MC68HC11K0VFU3 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:8-Bit Microcontroller |
| MC68HC11K0VFU4 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:8-Bit Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。