- 您現在的位置：買賣IC網 > PDF目錄382301 > MC4GH02GNMCA-2SA00 (SAMSUNG SEMICONDUCTOR CO. LTD.) SAMSUNG MultiMediaCard PDF資料下載
參數資料
| 型號： | MC4GH02GNMCA-2SA00 |
| 廠商： | SAMSUNG SEMICONDUCTOR CO. LTD. |
| 英文描述： | SAMSUNG MultiMediaCard |
| 中文描述： | 三星多媒體 |
| 文件頁數： | 18/102頁 |
| 文件大小： | 1384K |
| 代理商： | MC4GH02GNMCA-2SA00 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁
MultiMediaCard
TM
18
Sep.22.2005
Revision 0.3
The following sections provide valuable information about the electrical interface.
5.4.1 Power Up
The power-up of the MultiMediaCard bus is handled locally in each card and the bus master. See Figure 5-3
Figure 5-3 : Power-up Diagram
- After power up (including hot insertion, i.e. inserting a card when the bus is operating) the card enters the
idle state
. Dur-
ing this state the card ignores all bus transactions until CMD1 is received.
- The maximum initial load (after power up or hot insertion) that the MultiMediaCard can present on the VDD line shall be
a maximum of 10 uF in parallel with a minimum of 330 ohms. At no time during operation shall the card capacitance on the
VDD line exceed 10 uF
- CMD1 is a special synchronization command used to negotiate the operation voltage range and to poll the card until it is
out of its power-up sequence. Besides the operation voltage profile of the card, the response to CMD1 contains a busy
flag, indicating that the card is still working on its power-up procedure and is not ready for identification. This bit informs
the host that the card is not ready. The host has to wait until this bit is cleared. The card shall complete its initialization
within 1 second from the first CMD1 with a valid OCR range.
- Getting the card out of
idle state
is up to the responsibility of the bus master. Since the power up time and the supply
ramp up time depend on application parameters as the bus length and the power supply unit, the host must ensure that
the power is built up to the operating level (the same level which will be specified in CMD1) before CMD1 is transmitted.
- After power up the host starts the clock and sends the initializing sequence on the CMD line. This sequence is a contigu-
ous stream of logical ‘1’s. The sequence length is the longest of: 1msec, 74 clocks or the supply-ramp-up-time; The addi-
tional 10 clocks (over the 64 clocks after what the card should be ready for communication) is provided to eliminate power-
up synchronization problems.
Every bus master has to implement CMD1. The CMD1 implementation is mandatory for all MultiMediaCards.
Supply voltage
time
Supply ramp up time
Bus master supply voltage
CMD1
CMD1
V
DD
max
Memory field
working
voltage range
Power up time
Initialization delay:
The longest of:
1 msec, 74 clock cycles
or the supply ramp up time
Optional repetitions of CMD1
until the card is responding
with busy bit set.
V
DD
min
CMD2
N
CC
CMD1
N
CC
N
CC
Initialization sequence
Card logic
working
voltage range
First CMD1 to card ready
5.4 Electrical Interface
相關PDF資料 |
PDF描述 |
|---|---|
| MC206 | THIN SMD LOW/MEDIUM-FREQUENCY CRYSTAL UNIT |
| MC2300 | Navigator Motion Processor |
| MC26LS30 | Dual Differential Quad Single-Ended (EIA-423-A) Line Drivers |
| MC26LS30D | CABLE GLAND, PG29 |
| MC26LS30DR2 | Dual Differential Quad Single-Ended (EIA-423-A) Line Drivers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC4M | 制造商:G & J HALL 功能描述:STEP DRILL MULTICUT 4-12MM X 2MM 制造商:G & J HALL 功能描述:STEP DRILL, MULTICUT, 4-12MM X 2MM |
| MC-4-MALE | 制造商:Multi-Contact USA 功能描述: |
| MC4MANUAL | 制造商:Omron Corporation 功能描述: |
| MC-4R128CEE6B | 制造商:NEC 制造商全稱:NEC 功能描述:Direct Rambus DRAM RIMM Module 128M-BYTE 64M-WORD x 16-BIT |
| MC-4R128CEE6B-653 | 制造商:NEC 制造商全稱:NEC 功能描述:Direct Rambus DRAM RIMM Module 128M-BYTE 64M-WORD x 16-BIT |
發布緊急采購，3分鐘左右您將得到回復。