- 您現在的位置：買賣IC網 > Datasheet目錄40 > DS7505U+T&R (Maxim Integrated)IC DGTL THERMOMETER 2WIRE 8-USOP Datasheet資料下載
參數資料
| 型號： | DS7505U+T&R |
| 廠商： | Maxim Integrated |
| 文件頁數： | 6/14頁 |
| 文件大小： | 197K |
| 描述： | IC DGTL THERMOMETER 2WIRE 8-USOP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 3,000 |
| 功能： | 溫度計，恒溫計 |
| 傳感器類型： | 內部 |
| 感應溫度： | -55°C ~ 125°C |
| 精確度： | ±2°C（最小值） |
| 拓撲： | ADC（三角積分型），比較器，寄存器庫 |
| 輸出類型： | I²C?/SMBus? |
| 輸出警報： | 無 |
| 輸出風扇： | 無 |
| 電源電壓： | 1.7 V ~ 3.7 V |
| 工作溫度： | -55°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-uMAX |
| 包裝： | 帶卷 (TR) |
Shutdown Mode
For power-sensitive applications, the DS7505 offers a
low-power shutdown mode. The SD bit in the configura-
tion register controls shutdown mode. When SD is pro-
grammed to 1, the conversion in progress is completed
and the result stored in the temperature register, after
which the DS7505 goes into a low-power standby state.
The O.S. output is cleared if the thermostat is operating
in interrupt mode and O.S remains unchanged in com-
parator mode. The 2-wire interface remains operational
in shutdown mode, and writing a 0 to the SD bit returns
the DS7505 to normal operation. Upon power-up in
shutdown mode, the DS7505 executes one tempera-
ture measurement. The result is stored in the tempera-
ture register, after which the DS7505 enters the
shutdown state.
Operation疶hermostat
The DS7505 thermostat can be programmed to power
up in either comparator mode or interrupt mode, which
activate and deactivate the open-drain thermostat out-
put (O.S.) based on user-programmable trip points
(T
OS
and T
HYST
). The T
HYST
and T
OS
registers contain
Celsius temperature values in twos complement format
and consist of EEPROM that is shadowed by SRAM.
Once written to the shadow SRAM, values can be
stored in EEPROM by issuance of a Copy Data com-
mand from the master (see the Command Set section
for more details). The device can operate using the
shadow SRAM only or using the EEPROM. If the
EEPROM is used, the values are NV and can be pro-
grammed prior to installation of the DS7505 for stand-
alone operation. The factory power-up settings for the
DS7505 are with the thermostat in comparator mode,
active-low O.S. polarity, overtemperature trip-point
(T
OS
) register set to 80癈, the hysteresis trip-point
(T
HYST
) register set to +75癈, and the number of con-
secutive conversion to trigger O.S. set to 1. If these
power-up settings are compatible with the application,
the DS7505 can be used as a stand-alone thermostat
(i.e., no 2-wire communication required) with no pro-
gramming required prior to installation. If interrupt
mode operation, active-high O.S. polarity, different T
OS
and T
HYST
values, or a different number of conversions
to trigger O.S. are desired, they must be programmed
into the EEPROM either after initial power-up or prior to
IC installation. The programmed values then become
the new power-up defaults.
In both operating modes, the user can program the
thermostat-fault tolerance, which sets how many con-
secutive temperature readings (1, 2, 4, or 6) must fall
outside the thermostat limits before the thermostat out-
put is triggered. The fault tolerance is set by the F1 and
F0 bits in the configuration register. The default factory
power-up setting for fault tolerance is 1 (F1 = 0, F0 = 0).
The data format of the T
OS
and T
HYST
registers is iden-
tical to that of the temperature register (see Figure 3),
i.e., a 2-byte twos complement representation of the
trip-point temperature in degrees Celsius with bits 3
through 0 hardwired to 0. After every temperature con-
version, the measurement is compared to the values
stored in the T
OS
and T
HYST
registers. The O.S. output
is updated based on the result of the comparison and
the operating mode of the IC. The number of T
OS
and
T
HYST
bits used during the thermostat comparison is
equal to the conversion resolution set by the R1 and R0
bits in the configuration register. For example, if the
resolution is 9 bits, only the 9 MSBs of T
OS
and T
HYST
are used by the thermostat comparator.
The active state of the O.S. output can be programmed
by the POL bit in the configuration register. The power-
up factory default is active low (POL = 0).
If the user does not wish to use the thermostat capabili-
ties of the DS7505, the O.S. output should be left
unconnected. Note that if the thermostat is not used,
the T
OS
and T
HYST
registers can be used for general
storage of system data.
Comparator Mode
When the thermostat is in comparator mode, O.S. can
be programmed to operate with any amount of hystere-
sis. The O.S. output becomes active when the mea-
sured temperature exceeds the T
OS
value a
consecutive number of times as defined by the F1 and
F0 fault tolerance (FT) bits in the configuration register.
O.S. then stays active until the first time the tempera-
ture falls below the value stored in T
HYST
. Putting the
device into shutdown mode does not clear O.S. in com-
parator mode. Thermostat comparator mode operation
with FT = 2 is illustrated in Figure 4.
Digital Thermometer and Thermostat
6 _______________________________________________________________________________________
相關PDF資料 |
PDF描述 |
|---|---|
| DS75LVU+T&R | IC SENSOR TEMP DIGITAL 8MSOP |
| DS75LXS+ | IC THERMOMETER/STAT DIG 8-SOIC |
| DS75U+T&R | IC THERMOMETER/STAT DIG 8-MSOP |
| FAN4010IL6X_F113 | IC CURRENT SENSE 0.2% 6MLP |
| FAN5069EMTCX | IC REG DL BCK/LINEAR 16TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS75-08B | 功能描述:整流器 75 Amps 800V RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
| DS750PED-3 | 功能描述:線性和開關式電源 12V output 750W Platinum RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
| DS750PED-3-001 | 制造商:Emerson Network Power - Embedded Power 功能描述:12V OUTPUT, 750W 1U X 3.4 X 7.8 PLATINUM WITH REVERSE AIR - Bulk 制造商:ARTESYN EMBEDDED TECHNOLOGIES 功能描述:AC/DC CONVERTER 12V 12V 750W 制造商:Emerson Embedded Power 功能描述:AC/DC CONVERTER 12V 12V 750W 制造商:Emerson Network Power - Embedded Power 功能描述:12V output, 750W 1U x 3.4 x 7.8 Platinum with reverse air |
| DS750PED-3-402 | 制造商:Emerson Network Power - Embedded Power 功能描述:- Bulk |
| DS750PED-3-403 | 制造商:Emerson Network Power - Embedded Power 功能描述:12V OUTPUT, 750W 1U X 3.4 X 7.8 PLATINUM WITH REVERSE AIR - Bulk |
發布緊急采購，3分鐘左右您將得到回復。