- 您現在的位置：買賣IC網 > PDF目錄371077 > MC92600 (Motorola, Inc.) High-speed, Full-duplex, Serial Data Interface(高速全雙工串行數據接口) PDF資料下載
參數資料
| 型號： | MC92600 |
| 廠商： | Motorola, Inc. |
| 英文描述： | High-speed, Full-duplex, Serial Data Interface(高速全雙工串行數據接口) |
| 中文描述： | 高速，全雙工，串行數據接口（高速全雙工串行數據接口） |
| 文件頁數： | 57/82頁 |
| 文件大小： | 1056K |
| 代理商： | MC92600 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁當前第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁
Chapter 6. Electrical SpeciTcations and Characteristics
6-11
Electrical Characteristics
6.1.4 Power Supply Requirements
The board design should have a minimum of two solid planes of one ounce copper. One
plane is to be used as a ground plane and the second plane is to be used for the 1.8V supply.
It is recommended that the board has its own 1.8V and 3.3V regulators with less than 0.1%
ripple.
6.1.5 Phase-Locked Loop (PLL) Power Supply Filtering
An analog power supply is required for the internal PLL. The PLLAVDD signal provides
power for the analog portions of the PLL. To ensure stability of the internal clock, the power
supplied to the PLL is Tltered using a circuit similar to the one shown in Figure 6-11. For
maximum effectiveness, the Tlter circuit is placed as close as possible to the PLLAVDD
ball to ensure it Tlters out as much noise as possible. The ground connection should be near
the PLLAGND ball. The 0.003
m
F capacitor is closest to the ball, followed by the 0.3
m
F
capacitor, and Tnally the 3
W
resistor to Vdd on the 1.8V power plane. The capacitors are
connected from PLLAVDD to the ground plane. Use ceramic chip capacitors with the
highest possible self-resonant frequency. All traces should be kept short, wide and direct.
Figure 6-11. PLL Power Supply Filter Circuit
6.1.6 Decoupling Recommendations
The WarpLink Quad requires a clean, tightly regulated source of power to ensure low jitter
on transmit, and reliable recovery of data in the receiver. Recommendations for appropriate
decoupling are outlined below.
￥
Only surface mount technology (SMT) capacitors should be used, to minimize
inductance. Connections from all capacitors to power and ground should be done
with multiple vias to further reduce inductance.
￥
The board should have about 10 x 10nF SMT ceramic chip capacitors as close as
possible to the 1.8V (Vdd and XVdd) balls of the device. The board should also have
about 10 x 10nF SMT ceramic chip capacitors as close as possible to the 3.3V
(OVdd) balls of the device. Where the board has blind vias, these capacitors should
be placed directly below the WarpLink Quad supply and ground connections. Where
the board does not have blind vias, these capacitors should be placed in a ring around
the WarpLink Quad, as close to the supply and ground connections as possible.
VDD
3
W
0.003 μF
PLLAVDD
0.3 μF
GND
相關PDF資料 |
PDF描述 |
|---|---|
| MC9S12DB128B | MC9S12DT128B |
| MC9S12DB128BCFU | MC9S12DT128B |
| MC9S12DB128BCPV | MC9S12DT128B |
| MC9S12DB128BMFU | MC9S12DT128B |
| MC9S12DB128BMPV | MC9S12DT128B |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC92600JUB | 功能描述:IC SERDES QUAD 1.25GBAUD 217PBGA RoHS:否 類別:集成電路 (IC) >> 接口 - 串行器，解串行器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 功能:解串器 數據速率:2.5Gbps 輸入類型:串行 輸出類型:并聯 輸入數:- 輸出數:24 電源電壓:1.8 V ~ 3.3 V 工作溫度:-40°C ~ 105°C 安裝類型:表面貼裝 封裝/外殼:64-TQFP 裸露焊盤 供應商設備封裝:64-TQFP-EP（10x10） 包裝:管件 |
| MC92600VMB | 制造商:Freescale Semiconductor 功能描述: |
| MC92603VF | 功能描述:IC TXRX ETH QUAD GIG 256-MAPBGA RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
| MC92603VM | 功能描述:IC ETH TXRX QUAD GIG 256-MAPBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| MC92604VM | 功能描述:IC ETH TXRX DUAL GIG 196-MAPBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。