- 您現在的位置：買賣IC網 > Datasheet目錄49 > 4432-T-B1 B 915 (Silicon Laboratories Inc)KIT DEV TEST EZRADIOPRO SI4432 Datasheet資料下載
參數資料
| 型號： | 4432-T-B1 B 915 |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 40/47頁 |
| 文件大小： | 799K |
| 描述： | KIT DEV TEST EZRADIOPRO SI4432 |
| 標準包裝： | 1 |
| 附件類型： | 測試卡，收發器，915MHz |
| 適用于相關產品： | EZRadioPRO? |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁當前第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
Si4430/31/32-B1
40
Rev 1.1
5.8. Crystal Oscillator
The Si4430/31/32 includes an integrated 30 MHz crystal oscillator with a fast start-up time of less than 600 祍
when a suitable parallel resonant crystal is used. The design is differential with the required crystal load
capacitance integrated on-chip to minimize the number of external components. By default, all that is required off-
chip is the 30 MHz crystal.
The crystal load capacitance can be digitally programmed to accommodate crystals with various load capacitance
requirements and to adjust the frequency of the crystal oscillator. The tuning of the crystal load capacitance is
programmed through the xlc[6:0] field of "Register 09h. 30 MHz Crystal Oscillator Load Capacitance." The total
internal capacitance is 12.5 pF and is adjustable in approximately 127 steps (97fF/step). The xtalshift bit provides a
coarse shift in frequency but is not binary with xlc[6:0].
The crystal frequency adjustment can be used to compensate for crystal production tolerances. Utilizing the on-
chip temperature sensor and suitable control software, the temperature dependency of the crystal can be
canceled.
The typical value of the total on-chip capacitance Cint can be calculated as follows:
Cint = 1.8 pF + 0.085 pF x xlc[6:0] + 3.7 pF x xtalshift
Note that the coarse shift bit xtalshift is not binary with xlc[6:0]. The total load capacitance Cload seen by the crystal
can be calculated by adding the sum of all external parasitic PCB capacitances Cext to Cint. If the maximum value
of Cint (16.3 pF) is not sufficient, an external capacitor can be added for exact tuning. Additional information on
calculating Cext and crystal selection guidelines is provided in AN417: Si4x3x Family Crystal Oscillator.
If AFC is disabled then the synthesizer frequency may be further adjusted by programming the Frequency Offset
field fo[9:0]in "Register 73h. Frequency Offset 1" and "Register 74h. Frequency Offset 2", as discussed in "3.5.
Frequency Control" on page 25.
The crystal oscillator frequency is divided down internally and may be output to the microcontroller through one of
the GPIO pins for use as the System Clock. In this fashion, only one crystal oscillator is required for the entire
system and the BOM cost is reduced. The available clock frequencies and GPIO configuration are discussed
further in "8.2. Microcontroller Clock" on page 51.
The Si4430/31/32 may also be driven with an external 30 MHz clock signal through the XOUT pin. When driving
with an external reference or using a TCXO, the XTAL load capacitance register should be set to 0.
5.9. Regulators
There are a total of six regulators integrated onto the Si4430/31/32. With the exception of the digital regulator, all
regulators are designed to operate with only internal decoupling. The digital regulator requires an external 1 礔
decoupling capacitor. All regulators are designed to operate with an input supply voltage from +1.8 to +3.6 V. The
output stage of the of PA is not connected internally to a regulator and is connected directly to the battery voltage.
A supply voltage should only be connected to the VDD pins. No voltage should be forced on the digital regulator
output.
Add R/W Function/Description
D7
D6
D5
D4
D3
D2
D1
D0
POR Def.
09 R/W Crystal Oscillator Load
Capacitance
xtalshift
xlc[6]
xlc[5]
xlc[4]
xlc[3]
xlc[2]
xlc[1]
xlc[0]
7Fh
相關PDF資料 |
PDF描述 |
|---|---|
| 5250AT43A200E | ANTENNA CHIP 5.25GHZ WIFI |
| 5250BL14B100T | BALUN CERAMIC CHIP WIFI 5250MHZ |
| 5250BL15B100E | BALUN CERAMIC CHIP WIFI 5250MHZ |
| 5325BL15B050E | BALUN CERAMIC CHIP WIFI 5325MHZ |
| 5512BL15B100E | BALUN CERAMIC CHIP WIFI 5512MHZ |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 4432-T-B1C470 | 制造商:Silicon Laboratories Inc 功能描述:One antenna Tx/Rx test card 470MHz |
| 4432-T-B1C915 | 制造商:Silicon Laboratories Inc 功能描述:One antenna Tx/Rx test card 915MHz |
| 4432W-1"x72yd | 功能描述:膠帶 70002457219 4432W YDA WHITE 1 IN X 72 YD BULK RoHS:否 制造商:3M Electronic Specialty 產品:Tapes 類型:Shielding 描述/功能:EMI/RFI Foil Shielding Tape 顏色: 材料:Copper Foil 寬度:1 in x 18 yds |
| 4432W-1/2"x72yd | 功能描述:膠帶 4432WYDA WHITE 1/2X72YD BULK RoHS:否 制造商:3M Electronic Specialty 產品:Tapes 類型:Shielding 描述/功能:EMI/RFI Foil Shielding Tape 顏色: 材料:Copper Foil 寬度:1 in x 18 yds |
| 4432W-1/2X72YD | 制造商:3M Electronic Products Division 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。